Progress has been a little slow lately. I have be indecisive about the state of the fairing. I have found it difficult to determine what is correctly faired and what needs work.
Well anyway, today I did some more checks and have concluded that from frame 0 to 5 is ok, but forward of that needs more work.
So I decided to cut the limbers as I wasn't in the mode for fairing. Cutting the limbers with the router was a relatively simple task but I was surprised how long it took to cut them all. I still have the athwartship limbers to cut, I will be posting I the glen - l site regarding where the best place for these is.
Lastly I cut up my first sheet of ply. The instructions allow for a full sheet to be used on both side at the aft end for the first layer. I have the first sheet trimmed to an oversize shape.
No comments:
Post a Comment