A bit of an oops

While trial fitting the second lamination of the chine I have discovered that I have a bit much twist in the chine at the point it lands on the stem. The result will be that when the bevel is applied to the stem, there will only be 1 point that flows nicely on to the chine.

The photo below illustrates this; the leading edge of the chine should be more or less parallel with the stem edge.

Never mind, I will just have to do a bit of extra fairing and possible add a wedge to get enough chine to land the bottom planks on. On the flip side I have the angle cut for the second chine lam to hit the stem and it's sitting quite nicely, still needs a little bit of fine tuning.